3. OPERATION 3.10 SECURING AND TRANSPORTING There are three tie down points provided for securing the skid steer while transporting. One at the lower front and two at the rear (Fig. 3.9). Be sure the trailer and/or truck is of adequate size and capacity to safely transport your skid steer. Measure the clearance height of the machine and trailer or truck, and post it in the cab of the truck. Before loading the skid steer make sure the ramps and parking surface are free of all oil, grease, ice, etc. and of sufficient strength to support the load. Know the local rules and regulations, and make sure your truck and trailer is equipped with the correct safety equipment. C3408 Fig.
3.9 When loading a skid steer with an attachment, always load the heavy end first. IMPORTANT When moving your skid steer on or off a transport vehicle, drive slowly and keep the machine centered. Once the skid steer has been loaded, lower the attachment to the floor, stop the engine and engage the park brake. Install chains at the front and rear tie down locations, and securely attach to the transport vehicle. Ramps must be of sufficient strength to support the weight of your skid steer. Wooden ramps can break and cause personal injury. NOTE: Minimum 3/8 in.
grade 40 chain is required WARNING C361 To avoid personal injury, lower the lift arms, shut off the engine, raise the seat bar and cycle the lift arm and bucket controls to ensure they are locked. Then, unlatch the seat belt and exit the loader. Do not enter or exit with the engine running unless as specified in this manual or under specific service and backhoe operating procedures.
WARNING C362 33 SAFE SHUTDOWN PROCEDURES - Stop machine - Stop machine - Lower the bucket and other attachments flat on the ground - Position controls in neutral - Raise operator seat bar to engage parking brake - Idle engine for short cool-down period - Stop engine - Cycle all controls to ensure they are locked in neutral - Unbuckle seat belt - Remove ignition key and lock covers and closures