4. MAINTENANCE 4. V-Belt Tension Check the V-belt tension midway between the crankshaft pulley and alternator pulley (Fig. 4.8C). Deflection should be between 1/4 to 3/8 in. (7-9 mm). Fan Pulley Alternator Pulley 5. Adding Fuel Use No. 2 diesel fuel only. Total tank capacity 28.7 gal (109 L). Before adding fuel to the loader the key switch must be off and the engine must be cool. Remove the fuel cap (Fig. 4.8D). Use a clean approved safety container to add fuel. Add fuel only in an area that is well ventilated and away from open flames or sparks - NO SMOKING! 6. Fuel Filter Replacement Crankshaft Pulley The fuel filter is located in the engine compartment on the left hand side (Fig. 4.8E).
The fuel filter should be removed every 100 hours and any water or dirt found in the element drained off. Change the filter every 300 hours. Fig. 4.8C C-834 To replace the filter; close the fuel inlet line shut - off located on the side of the fuel tank (Fig. 4.8F). Remove the filter element (Fig. 4.8E). Lubricate the seal on the new filter and install the filter hand tight. Open the fuel inlet shut - off. It may be necessary to remove air from the fuel system after changing the filter element. (Refer to Section 4.8-7). Fuel Tank C3948 Fig.4.8D Hand Primer Fuel Filter To avoid personal injury never add fuel to the loader when the engine is running or is hot. NO SMOKING.
WARNING C3786 Fig 4.8E 51