Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION (E) Fore-and-aft adjustment of seat cushion Operate lever (4) up, set the seat cushion to the desired position, then release the lever. Fore-and-aft adjustment: 60 mm (2.4 in) (G) Adjusting headrest angle Rotate the backrest to the front or rear and set to the desired angle. Amount of adjustment: 38 degrees (H) Adjusting headrest height Move the headrest up or down and set to the desired height. Amount of adjustment: 100 mm (3.9 in) 3 - 85 (D) Setting seat for weight to adjust the suspension to match the operator's weight.

To protect the operator, it is necessary to adjust the suspension to match the operator's weig Push lever (3) down to lower the seat to the lowest position, then pull lever (3) up fully (pull it un til a click can be felt). When the lever is released, the weight adjustment is carried out automatically. To ensure that the weight adjustment is carried out correctly, the operator should sit in the norm al operating position when operating the lever. If the operat or raises his body from the seat or changes the amount of weight ap plied to the seat during adjustment, the air in th e suspension may be discharged.

When operators change shifts, the new operator should push lever (3) down to lower the seat t o the lowest p osition, then pull lever (3) up fully (pull it until a click it is felt). When the lever is released, the weight a djustment is carried out automatically. If lever (3) is pulled lightly, the weight a djustment starts, but always pull the lever up fully (pull it until a clic k is felt) before releasing it. REMARK When making initial adjustment or when adjusting the weight settings when operators change shifts, set the damping force of the suspension da damper"), then adjust it to match the to the hard setting and the height of seat goes down, set the damping fo the weight again.

After completing a damper to the desired strength. mper to the soft setting (for details, see "Adjusting har dness of sus pension operator's weight. If the damping force of the suspensi on damper is left set the seat is adjusted, even if the height is raised, the sea t may go dow n. If the rce of the suspension damper to the soft setting, lower the seat, the n adjust djustment of the weight and height, set the damping for ce of the sus pension nsion must be adjusted to match the operator's weight. Adjust the weight To protect the operator, the suspe before starting operations. When adjusting, do not remove your weight from the seat or change the load in any other w ay.

If this is d one, the air may be released from the suspe nsion's seat. (F) Adjusting reclining angle k cushion to the front or rear. Operate lever (5) up and move the bac But your back firmly against the seat ba ck when carrying out this adjustment. If you move your back away f rom the seat back, the seat back may suddenl y spring forward. es is free) Amount of adjustment Forward tilt: 20 degrees (over 20 degre Rear tilt: 60 degrees NOTICE If the seat back is reclined too far, the seat b ack may hit the rear glass, so use it in a position where it doe s not contact t he glass.