. OPERATION OPERATION APPROACHING FACING NOTICE 3 - 127 When approaching the facing and loweri ng the bucket to the ground, do not drop the bucket sudde ground. If the bucket is dropped suddenl y, the bucket, work equipment, area around the pins, and th subjected to excessive shock, and this w ill lead to damage or deformation of various parts of the ma In addition, the front wheels were come o ff the ground, so this will cause the machine to slip. When lowering the bucket to the ground, reduce the lowering speed of the bucket when it is close to slowly into contact with the ground.
D o not set the cutting edge of the bucket at a large angle to the ground surface when digging or low angle between the bucket and the ground surface to a maximum of 8°. If angle between the cutting ed ground surface is more than 8° when dig ging or lowering the roadbed, there is danger of damage to D o not load the bucket or scoop up the loa d with the load on the corner of the bucket or the load on one w ill cause the machine to twist and will r educe the service life of the work equipment and the frame. 1. Set the machine to the travel postu 2. Set the shift position to F2, then gr adually depress the accelerator pedal and raise the tr 3.
When lowering the bucket to the gr ound, reduce the lowering to the ground and bring it t and the ground surface a and dump so that only the the ground. he rock and change the . the condition of the road hard cutting face rock or t. speed of the bucket when it is close slowly into contact with the ground. speed of the bucket when it is close slowly into contact with the ground. 4. Make angle (a) between the bucke maximum of 8°, and operate the tilt cutting edge comes in contact with 5. Drive forward at right angles to t direction that the machine is facing 6. Operate the accelerator to match surface so that the tires do not slip. 7. Scoop up the gathered rock.
Load boulders in the middle of the bucke boulders in the middle of the bucke