Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING diagram at right. 3 - 160 This machine must not be to wed except in emergencies. When towing the machine, take the following precautions. Before releasing the brak es, put blocks under the wheels to prevent the machine from moving. If the wheels are not blocked, the machine may suddenly move. When towing a machine, tow it at a low speed of less t han 2 km/h (1.2 MPH), and for a distance of a few meters to a place where repairs c an be carried out. The machine should be towed only in em ergencies. If the machine must be moved long dista nces, use a transporter. the same class as the machine being towed.

Use a towing machine of Check that the towing ma chine has ample braking power, weight, and rimpull to allow i t to control both machines on slopes or on the tow ro ad. pin for both the towing machine and the machine being towed. Use the specified towing pin for both the towing machine and the machine being tow To protect the operator if t he towing wire or towing bar b reaks, install protective plates o n both the towing machine and the machine being to wed. ing wire as small as possible. he center lines of the two machines to within 30 degrees. Keep the angle of the tow ing wire as small as possibl Keep the angle between t When towing down a slop e, use two towing machines.

One machine should be uphill f rom the disabled machine and should be connected with towing wire or a drawbar to pull the disabled machine ba ck and keep it stable. The other machine should tow Towing may be carried o requirements for towing. Towing on flat horizontal surfaces will require the m