Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 5. Loosen radiator cap (4) slightly to release the pressure, then remove the cap. coolant. REMARK 4 - 27 1. Stop the machine in a horizontal plac 2. Stop the engine. over (1). 3. Open engine side c 4. Tighten valve (3) of corrosion resistor (Only when corrosio n resistor is used 6. Prepare a container to catch the supercoolant 7. Insta ll hoses to the c oolant drain port o f radiato r drain plugs (5) and and (6), the Use the s upplied hose to prevent coolant from spraying out into the surrounding area. 8. After draining the co olant, close drain plug s (5 ) and 9. Add t ap water throu gh radiator water filler (4). 10.

Whe n the radiator is full, start the engine, and run it at low idle. Keep the engine run ning at low idle fo r 10 minutes u ntil the coolant temperature reach es more than 90°C (194 °F). the engine. drain plugs (5) and (6), and drain the water. draining the water, close drain plugs (5) and (6), and remove the hoses. 11. Stop 12. Open drain plugs (5 ) and (6), and dra in th 13. After draining the w ater, close drain p lugs (5) a nd (6 ), and