. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 28 14. Replace corro For details of t he procedure for r eplacing the corrosion r esistor see "REPLA (PAGE 4-69)" (Only when c orrosion resistor is 15. Open valve (3 ) of corrosion resi (Only when c orrosion resistor is 16. through water filler port (4) of th e radiator up to the fille r hole. For details of t he mixing proporti on of Supercoolant and water, see "Mixing ra te of water and a 17. To bleed the a ir from the cooling system, run the engin e at low idle for 5 min utes, and for a f urther 5 min utes at high idle. ) (When doing this, leave the radi ator cap off. 18.
Open drain pl ug (8) and drain th e coolant fro m inside s ub tank (7). Flush the inside of the sub t ank, then a dd coolant up to a point midway between the FUL L and LOW marks. 19. Stop the engin e, wait for approx. 3 minutes, t hen add ta p water until the water level is near the w ater filler po rt, and tigh ten the cap. Check th e coolant level an d add water if necessa ry.