Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK AXLE OIL LEVEL, ADD OIL WARNING Tightening torque: 127 to 177 Nm (13.0 to 18.0 kgm, 94.0 to 130.2 lbft) 4 - 30 The parts and oil are at high temperature imm ediately after the engine i s stopped, and ma y cause burns. Wait for the temperature to go down befor Perform this pro cedure if there is any si gn of oil on the axle case. Inspect the mac hine on a horizontal sur face. (If the road surf ace is at an angle, the oi l level cannot b e checked correctly.) chine in a horizontal place. 1. Stop the ma 2. Stop the en 3. Remove lev 4. Check that 5. If the oil is n oil filler (F). 6. If the oil lev 1. Stop the ma chine in a horizontal pla 2.

Stop the en gine, then wait for the oi l temperature to go down. 3. Remove lev el plug (1). the oil level is near the bottom of the plug hole. 4. Check that the oil level is near the b ottom of the pl ug hole. 5. If the oil is n ot near the bottom edge of the hole, add oil through el is correct, install level plug (1) 6. If the oil lev el is correct, install level CLEAN AXLE CASE BREATHER 1. Stop the ma 2. Stop the en 3. Use a brus breather. 4. After remov remove the When clean (front and re After remov from enterin 5. Install the b When clean (front and re 1. Stop the ma chine in a horizontal pla 2. Stop the en 3. Use a brus breather, and soak it in flushing liquid t o clean it.

ing the breather, clean t he breathers at two places ar). ing the breather, take st eps to prevent dirt or d ust g the mount. reather. 5. Install the b ing the breather, clean t he breathers at two places ar).