Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN RADIATOR, OIL COOLER, AFTERCOOLER FINS WARNING oil so 4 - 32 If compressed ai r, high-pressure water, or steam hits your b ody direct ly or dirt is sent flying by the com pressed air, high-pressure water, or steam, there is danger of perso nal injury. Always wear protective glasses, dust mask, and ot her protective equipment. Carry out clea ning if any dirt or mud is seen stuck to the radiator, oil cooler, or aftercooler f 1. Stop the m achine on horizontal ground and turn the parking ch ON. ngine. king brake swit 2. Stop the e 3.

Open door (1) at the side of the ra diator guard, ins ert the no zzle between o compress rear of the il cooler (2) and rad iator assembly (3), and use ed air to blow out the m ud or dirt out to the front and machine. 4. If the mud or dirt cannot be remo ved from afterco oler (4), o pen door (5) of mud and d the engine hood and u se compressed a ir to blow the irt off. e water to flush out the mud or dirt collected inside sembly (3). 5. Finally, us radiator as NOTICE If steam jet noz zle (6) is brought to close to fins (7) of the radiato If cooler, or afterc ooler, there is danger th at the fins may be damage g. ne when washing. m2, 1420 PSI} {0.1 in} .

100 mm {3.9 in} keep a good dis Use the followin tance away when cleanin g conditions as a guideli Jet pressure (A) : Max. 9.8 MPa {100 kg/c Nozzle diameter (B): Max. diameter 2 mm Distance (C) between nozzle and fin: Min REMARK Steam or wate r can be used instead of compressed