. MAINTENANCE SERVICE PROCEDURE REPLACE BUCKET TEETH WARNING 4 - 33 It is dangerous i f the work equipm ent moves b y mistak e when the teeth are being et the work eq uipment in a stabl e condition, stop the engine, and lock the work e quipment control levers securely wi th the ork equipment If the pins are hi t with a strong forc e, there is da nger tha t the pin may fly. Make sure that there is no pe rson in the surrounding rea. P ieces may fly d uring the replacem ent operatio n, so always we ar protective glasse s, gloves, and oth er protective equipment. BUCKET WITH TI P TOOTH h before they wear down as far as the adapter. Replace the teet h before they we ar down as far as t he ada 1.
2. 3. 1. Raise the bu cket to a suitable height, the n put blocks un der the bucket to ke ep the bottom of the bucket 2. Stop the eng 3. Remove pin (2), then remove When knock ing out the pin, slightly smaller than the pin, and kno ck out from the opposite s ide. REMARK I f it cannot be re moved by this m ethod, for s afety reasons, always contact your Ko to have the replacement carried out. 4. Clean bucke t and adapter (3) . 5. Fit new tooth (1) in adapter (3) , push in pi n (2) partially b y hand, then knock it in with a hamm er. 6. After operati ng the machine f or a few ho urs, check that the pin does not com e out.