. MAINTENANCE SERVICE PROCEDURE LUBRICATING does not move 4 - 34 . Using a grease pump, p ump in grease through the grease fittings . After greasing, wipe off any old grease that was pushe d out. (1) Work equipmen t control valve linkage ( 2 places If t he work equipment cont smoothly , apply If t he AJSS leve r is heavy o r stiff when adjuste d to the fron t or rear (2) AJSS lever Carry ou t cover. When doing this, fitting inside the (B) through gap not (3) AJSS lever f ore-and-aft slide rai Remove grommet (C) a nd pump in grease t hrough the g rease fitting on the inside of co ver (D).