Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM PISTON PUMP NOTICE 4 - 38 BLEEDING AIR FROM After replacing oil and filter element or cleaning strainer, b When changing the oil in th e hydraulic tank, or removing the piston pump, or removing the pi ping of the piston pump, bleed the air in the followin After bleeding air from pist on pump, bleed air from hydrau f the air is not bleed complete ly, the piston pump may be damag ed, so always carry out the air bleed Before bleeding the air from the piston pump, check that the hydraulic is filled with oil up to th e top of the sight gauge.

If the oil level is low, add oil.) The cap of the hydraulic ta nk remains removing, until the ai pump finishes. Leave the hydraulic tank c ap off until the air is completely 1. Before starting up the engine, loosen plug (1) installed the tube on the suction There is a plug on eac 2. Tighten plug (1) after c bled and oil begins to r 3. Keep plug (1) tightene filled with oil. 4. Loosen plug (2) install piston pump. There is a plug on eac 5. Tighten plug (2) after c onfirming that air has been com pletely bled and oil begins to ru 6. Start the engine and ru n for approx. 5 minutes at low i 7. Loosen plug (2) install ed on the elbow in the upper pa 8.

Tighten plug (2) after c onfirming that air has been com pletely bled and oil begins to ru 9. Stop the engine. 10. Check the oil level. If t he oil level is low, add oil to the specified level. For details, see " HYDRAULIC TANK, A