Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM HYDRAULIC CIRCUIT 4 - 39 1. Check that the hy draulic oil in the hydra ulic tank is at th e specified level. 2. Run the engine a t low idle, and extend a nd retract the st eering, bucket, a nd lif t arm cy linder s 4 to 5 times . Be careful not to ope rate the cylinder to the e nd of its stroke ( stop approx. 100 mm (3.9 in) b efore the en d of str oke). 3. Next, operate the steering, bucket, and li ft arm cylinders end of their stroke 3 to 4 times, then stop t he engine and lo air bleed plug (1) to bleed the air from th e hydraulic tank. bleeding the air, t ighten plug (1) again. 4.

Check the hydra ulic oil level and ensure that is correct, to "CHECK OIL (PAGE 4-48)". 5. Increase the eng ine speed, and repeat s tep 3 to bleed t until no more bub bles come out from plu If the engine is r un at high speed at firs moved to the en d of its stroke, the air n packing, etc. damage the pisto 6. After completing the air bleed operation, tighten plug (1) Tightening torque : 9.83 to 12.77 Nm (1.0 to 1.3 kgm, 7.2 to 9.4 lbft 7. Check the hydra ulic oil level and ensure that is correct, Refer to "CHECK OIL LEVEL IN HYDRAULIC T ANK, ADD OIL (PAGE