. MAINTENANCE SERVICE PROCEDURE 4 - 52 CHECK ALTERNATOR BELT TENSION, ADJUS T Carry o ut the inspection and adjustmen t work after rem oving cover (1). CHECKI NG t should normally deflect by about 20 mm (0.79 in) when The bel pressed with the fi nger (wit h a force of approx. 58.8 N (6 kg) at a pulley. point mi dway between the drive pulley and alternator ADJUST ING sen bolt (1) and lock nut (2). n adjustment nut (3) to adjust the belt tension so that the 1. Loo 2. Tur defl forc 3. Afte 4. Che of th not 5. If th adju If th initi of o 1. Loo sen bolt (1 ) and loc 2. Tur n adjustme nt nut (3 ection is ap prox. 20 mm (0.8 in) when pressed with a finger e of appro x. 58.8 N {6 kg}. and bolt (1).
r of the V-groove, and wear 3. Afte 4. Che r adjusting ck each pu , tighten lley for d locknut (2) amage, wea e V-belt. B e particu larly carefu l to check that t he V-belt is in contact with the b ottom of th e V-groove. e is no more al lowance for 5. If th e belt has elongate d and ther stment, or if the bel t is cut or c racked, replace the belt. e V-belt h as been r eplaced wi th a new part, t here will be al elongatio n, so ins pect and a djust it again aft er one-hour peration.