Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE 672.7 lbft) 2. If any stud bolt is broken, replace all the stud bolts for that wheel. accumulator, see Section "HANDLING ACCUMULATOR AND GAS SPRING (PAGE 4 - 54 CHECK FOR LOOSE WHEEL HUB NUTS, TIGHTEN If w heel hub nuts (1) are loose , tire wear will be increased and accidents may be caused Check for loose nuts, and When checking for loose direction of tightening to c Tightening torque: 735.7 t CLEAN ELEMENT IN AIR CONDITIONER RECIRCULATION FILTER 1. Open the filter inspection cover, remove the filter cover, then pull out the filter in the direction of the arrow. Note: when removing the filter facing to the side, push the seat down fully first. 2.

Clean with compressed air in the same way as for the fresh air filter. If the filter is extremely dirty, rinse it in water. After rinsing the filter, dry it completely before installing it again. CHECKING FUNCTION OF For details of handling the acc )". 2-42 BRAKE ACCUMULATOR If th e engine stops when the m achine is traveling, the oil pressure in the accumulator can be used to apply the brake as a n emergency measure. ground and lower the work equipment completely to the ground. mid-range speed for 1 minute, then stop the engine. y to the ON position and depress the brake pedal repeatedly. 1. 2. 3. 4.

Stop the machine on level ground and lower the work equipment completely to the g Apply the parking brake. Start the engine, run it at a Turn the starting switch ke y to the ON position and depress the brake pedal repeate If the brake oil pressure caution lamp does not light up even when the brake is de pressed 6 times, the gas pressure in the accumu lator is normal. If the brake oil pressure caution lamp lights up when the brake has been depresse d 5 or less times, the gas pressure in the accumu accumulator inspected. lator has probably dropped. Please contact your Komatsu distributor to have the REMARK Car ry out the check within 5 m inutes after stopping the engine.

If the machine is left wit h the engine stopped, the accumulator pressure will dro p and it will be impossible to check the cause of the proble m.