Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the seal surface of the new NOTICE 4 - 58 Remove transparent cup (2) fr broken or damaged, replace it Clean transparent cup (2) and seal with clean fuel or oil. 4. Install transparent cup (2) to t Tightening torque for cup: 10 5. Clean the filter holder, coat cartridge thinly with oil, then in NOTICE When adding fuel, do not remove s mall holes (A) on the dirty side. A fter adding fuel, remove cap (B) a A lways fill with clean fuel. Be caref t c p he fuel. In particular, center portion ap (B) when adding fuel. Be carefu ortion on the clean side. 6.

When installing, tighten until th e packing surface contacts the seal surface of t he filter ho lder, then tighten it 3/4 of a turn. If the filter cartridge is tightene d too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fue l will also leak from the packing, so always tighten the cor rect amount. When tightening with a filte r wrench, be extremely careful not t o dent o r damage the 7. Start the engine and run it at l ow idling for approx. 10 minutes unt il the engine speed sta bilizes.

Check fo r any sucking in of air or leakage of fuel from the transparent cup and s eal surface of the filter cartridge When replacing the fuel main filter car tridge, bleed the air after replacing the f ilter cartridge For details, see "REPLACE FUEL MAI Do not fill the fuel main filter cartridge