. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION OIL FILTER ELEMENT WARNING down. bolt (1), then remove cover (2) under the brake (6 to 8 kgm, 43.4 to 57.9 lbft) 4 - 59 The parts an d oil are at high temperatur e after the engine is stoppe d, and may cause serious burns . Wait for the temperature to g o down before cleaning the engine Wh en using compressed air, there is a hazard that dirt may be blo wn up and cause serious injury. Alw ays use safety glasses, dust mask, or other protective equipm 1. St op the engine and wait for the t emperature at all parts t o go 2. Lo mpone 3. S et a container under filter case ( 3) to catch the oil. 4.
R emove d rain plug (4) at the botto m of the filter case, drain the oil , then ti ghten the plug again. (3), then remove case (3). e inside of the case. 5. Lo osen h exagon part (5) of case (3), then remove case (3 6. R emove t he element and clean th e inside of the case. 7. R eplace t he filter gasket and O-ri ng with new parts. Coa t the ne w gask et and O-ring thinly with clean oil before installin g. 8. A ssemble the new element, then and stall it. ain mount tightening torque: 49 to 6 kgm, 36.2 to 43.4 l ase tightening torque: 58.8 to 78 9. R un the e ngine at idle for a short time, then check that th e oil is T up to the specified level.
For details, see "CHECK RANSMISSION OIL LEVEL, AD D OIL (PAGE 4-29)".