. MAINTENANCE SERVICE PROCEDURE CAUTION pump in grease through the grease BELT, ADJUST 4 - 60 LUBRICATE CENTER DRIVE SHAFT (3 places) If y o u fail to grease the drive s haft, the shaft wi ll brea k, and there is danger that th e broken shaft will cause machine. To avoid this proble m always mainta in the specified gr easing in terval . Using a grease pump fittings marked by the a .
After g reasing, wipe off any old greas e that was pushed CHECK FAN BELT FOR Check the V-belt and when the following conditions exist, replace or adj When th ere is a clearan ce between th e tension p ulley lever an d tip o f the adjustment scre When th e V-belt makes contact with th e bottom o f the groove i n each When th e V-belt is worn , and its surfac e is lo wer than t he oute When th e V-belt is crack ed or flaked. When th e V-belt makes an abnormal n oise. A device is installed to mai ntain the tensio n constant regardless o f any e longation of the V-belt to carry ou t adjustment unt il the V-belt is replaced. For details of th e replace AUTO-TENSIONER (PAG