. MAINTENANCE SERVICE PROCEDURE TIGHTEN ROPS CANOPY to 2242.2 lbft) 3. Install the cover. The tightening torque is large, so a power wrench is needed when tightening. Please request your Komatsu distributor to carry out this work. WARNING Prepare a filter wrench 4 - 69 1. Loosen the bolt, then remo 2. Check that there is no loo ROPS canopy. If any bolt i Tightening torque: 2452 to 3040 Nm (250 to 310 kgm, 18 08.3 REPLACE CORROSION RE (Onl y when corrosion resistor All th e engine parts are at high tem perature after the engine has been operated, so never replace the c artridge immediately afte finishing operations. e replacing the cartridge. Wait for the oil to cool down befor 1.
Stop the engine. 2. Open up the engine side co ver on the left side of the machine. 3. Close valve (2) on top of c Using a filter wrench, turn orrosion resistor (1). cartridge (2) to the left to remove it. 4. 5. Clean the filter holder of the filter head, coat the seal surfa ce of the new cartridge thinly w cartridge. When installing, bring the ith clean the oil, then install the gasket into contact with the seal 6. seal surface of the filter holder, then tighten approx. 2/3 turns. 7. Close valve (2). 8. Close the engine side cove r on the left side of the machin Afte r replacing the cartridge, st art the engine and check that th ere is no leakage of water fro m the filter seal surface