. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE CAUTION 4 - 72 When removing the filter cover, keep the filter pressed down by hand. The filter cover is being pushed by a sprin g, so if the filter cover mounting bolts are r emoved carelessly, there is dang er that the filter cover will spring out and 9. Remove mounting bolts (5) o f the 3 filter covers (4) at the top of the tank, then remove the covers. When doing this, the cover m ay fly off because of the force of spring (6), so keep the cover pushed down while removing the bolts. 10. Remove spring (6) and bypas s valve (7), then take out element (8). Check that there is no forei gn material inside the tank, then r (4).
set bypass valve (7), spring (6), olts, push down the cover and 11. 12. clean it. Fit a new O-ring to filter cove 13. Install the new element, then and cover (4) in the tank. When installing the cover b tighten the bolts evenly. 14. 15. Add engine oil through oil fill then install air bleed plug (1 er port (F) to the specified level, ) on filter case. The cap of the ving, until the air bleeding of the d oil to the specified level. For hydraulic tank remains remo piston pump finishes. Check the oil level, then ad 16. details, see "CHECK OIL LE VEL IN HYDRAULIC TANK, ADD OIL (PAGE 4-48)". 17. Check that there is no leakag e of oil from the filter cover mount.