Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the TANK, ADD OIL (PAGE 4-48)". 4 - 73 18. Loosen plug (9) installed above the tube on the suction si the piston pump, and als elbow in the upper part of There is a plug on each p Tighten plug (9) and (10) begins to run out of both Check the oil level. If the o level. For details, see "C 21. Fix the cap of the hydraul 22. Run the engine at low idl e, and extend and retract the ste ering, bucket, and lift arm cyli nders 4 to 5 times. Be careful not to operate the cylinder to the end of its stroke (s top approx. 100 mm (3.9 in) be fore the end of stroke).

NOTICE If the engine is run at high speed i mmediately after startup or a cylinde r is pushed up to its stroke end, air taken inside the cylinder may cause damage to the piston packing. 23. Next, operate the steering , bucket, and lift arm cylinders t end of their stroke 3 to 4 ti mes, then stop the engine and lo vent plug (1) to bleed th bleeding the air, tighten p 24. Check the hydraulic oil le vel and add oil to the specified l For details,see "CHECK ADD OIL (PAGE 4-48)". 25. Next, increase the engine Step 21 to bleed the air. Continue this operation until no air comes out from plug ( 26. After completely bleeding Tightening torque: 9.83 to 12.77 Nm (1.0 to 1.3 kgm, 7.2 to 9.4 27.

Lower the bucket horizon tally to the ground and stop the engine. 28. Check that the hydraulic o il is at the standard level. For det ails, see "CHECK OIL LEVEL I N HYDRAULIC TANK, ADD OIL (PAGE 4-48)". kage of oil from the filter cover mount. 29. Check that there is no lea kage of oil from the filter cover mount