Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING and may cause burns. Wait for the compartment. ring from breather (1), then remove the element with a new install the on the right side of the operator's compartment. 4 - 75 T emperature to go down before starting the wor W hen removing the oil filler cap, turn it slowly t o release t he intern al pressure, then the engine 1. Set t he bucket horiz ontally on the ground, then turn the parking brak e ON. 2. Stop the engine an d wait for the temperature at all parts to go dow 3. Ope 4. Remove the cap of 5. Remove the snap breather cap. Replace the filter e 6. breather cap and sn 7. Tighten the cap of o 8.

Clos part, then REMARK I t is possible to replace the element with the b reather i nstalled in the tank. However, if th e breather is remove d, do not wrap the taper thre ad of the breather with sea e when assembling careful not to tighte n too much.