. MAINTENANCE SERVICE PROCEDURE REPLACE BRAKE OIL TANK BREATHER WARNING cause burns. Wait for the REPLACE ELEMENT IN AIR CONDITIONER RECIRCULATION AIR FILTER, FRESH AIR FILTER 4 - 80 The temperature to go dow n before starting the work. When removing the oi l filler cap, turn it slow ly to release the internal pressure, then remove it. 1. Open the cover on top of the platform o n the left side of the cab. 2. Loosen bolt (1) at the top of the cap. 3. Remove the cap a nd take out the element. 4. Coat O-ring of the new element with g reas e, then ins 5. Align the cap with i ndent or protrusion of the body, the n tighten bolt (1). 6.
Close the cover on top of the platform o n the left side of the cab. Remove both the recir culation air filter and fres h air filter i n the same way as when clean ing, and replace them with new parts. For details of cleaning the recirculation air f ilter, see "CLE AN ELEMENT IN AIR CONDIT IONER RECIRCULATION FILTER (PAGE 4-54)" . the fresh air filter, see "CLEAN ELEMENT IN AIR CONDITIONER FRESH AIR FILTER For details of cleaning (PAGE 4-49)". CLEAN PPC CIRCU IT STRAINER ) of the PPC circuit strainer. er case and pull out the strainer, then wash ean diesel fuel.
in the strainer case, and install it with bolts l lever in TILT position and lift arm control sition, and after cylinder reaches stroke end, on for one minute. lever in DUMP position and lift arm control ition, and after cylinder reaches stroke end, on for one minute. 1. 2. 3. 4. 5. 6. 1. Remove 3 bolts (1 ) of the PPC circuit strainer. 2. Remove the strain er case and pull out the strainer, th en wash the strainer with cl Install the strainer (1). 4. Put bucket contro l lever in TILT position and lift arm control lever in FLOAT po keep in that positi Put bucket control lever in RAISE pos ition, and after cylinder r eaches str oke end, keep in that positi on for one minute. 6.
Bleed the air from the hydraulic circuit . For details, se e "BLEEDING AIR FROM PP C CIRCUIT (PAGE 4-36)".