Komatsu — METHOD OF ADJUSTING DISCHARGE FROM INJECTOR

. ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM One turn between the maximum and minimum positions change the discharge by 0.82 cc. After adjusting the discharge, be sure to tighten the lock nut. 6 - 12 2. I njector (SL1 1) tor is operated by the pressure from the pump, 1) The injec and it fee 2) To see if of indicat pin is ret lost, the 3) Adjust th screw (6 1] To re adjus stops 2] If the fully abov 1) The injec and it fee ds grease of the specifi ed quantity to the bearing. 2) To see if the injector works nor mally, check the o peration of indicat or pin (4) on its head. If the injector is normal, the pin is ret racted first.

If the pump stops and the pressur e is lost, the pin returns and it is res et for the next greasing . 3) Adjust th e discharge from the ) on its head. injector with adjustment osen lock nut (5) and turn screw (6 1] To re duce the discharge, lo urn tment screw clockwise . If the adjustme nt screw (at the stopper), the d ischarge is minimized. 2] If the adjustment screw is ret urned by 10 turns from the tightened position (m inimum discharg e) in 1] . e, the discharge is max imized (8.2 cc/st) adjusting the discharge from the injector, be s ure hten lock nut.

4) Although the injector can be ov erhauled and repaired, replace it with a spare one, if possible, wh en it has any troub Disch Loose any troub le. arge adjusting procedure for large-sized injector (SL-11) (Added to bucket pin) n lock nut (5) and turn adjustment screw (6) to adjust the discharge of grease made each time. Disch arge adjusting procedur e for large-sized i nject or (SL-11) (Added to bucket n lock nut (5) and turn adjustment screw (6) t o adjust the discharge of gre ase made eac h time Discharge (cc/cycle) Turn clockwise to stopper (Min. discharge) 0.82 Turn counterclockwise by 10 turns from above position (Max. discharge) 8.2