Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION position between LOW run the engine at abnormal exhaust gas color, noise, or vibration. problem is found, contact your Komatsu 3 - 99 IN COLD AR 1. Turn fuel c IDLE (MIN ) and HIG H IDLE (MAX) a medium s peed for abo ut 10 minutes wit 2. Operate b lade control lever (4) to the RAISE position , then keep the b lade raised to the maximum height and continue to relieve the circuit for 1 0 minutes. 3. Finally, op erate blade control lever (4) a nd ripper control lever to operate the blade a nd ripper cylinder s several times. If the oil t emperature in the work equipment is not properly time lag in the response of the work g.

pment is not properly raised, the re will be a equipmen t and steerin 4. After warm -up is completed, check gau ges and caution l amps for proper operation. If any problem is f ound, repair it. ight load until engine Continue ngine under a l ngine coolant te green range (B). (A): White (B): Green (C): Red r REMARK I f the power tra in oil temperature is not raised sufficiently, it wi ll take longer to acce lerate to the maximum speed . 5. Check for distributor If any