. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 143 BEFORE STORAGE e than one month), store as follows. When keeping in long-term storage (mor Clean and wash all parts, then store th e machine indoors. If the machine has to be stored outdoors, s elect level ground and cover the machine with a sheet. ents moisture from collecting. orage. rface of the hydraulic piston rods and the idler adjusting rods. Completely fill the fuel tank.
This prev Lubricate and change the oil before st Apply a thin coat of grease to metal su rface of the hydraulic piston rods and the idler adjustin Disconnect the negative terminals of th e battery and cover it or remove it from the machine and s tore it s eparately. Place all control levers in the neutral p osition, set the work equipment lock lever and parking brake le ver i n the LOCK position, and set the fuel contro l dial to the low idling position. To prevent corrosion, be sure to fill the cooling system with Supercoolant (AF-NAC) or permane nt type antifreeze (density between 30% and 68%).
If it is necessary to perform the rust-preventio n operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of o il will coat moving parts. At the same time, also charge the battery. wipe the grease off the hydraulic piston rod. ditioner, run the air conditioner. Before operating the work equipment, For machines equipped with an air con NOTICE If the machine has been stored without carryi ng out the monthly rust-prevention operation, consult y our K omatsu distributor before using it.
When using the machine after long-term storage, do as follows before using it. cylinder rods. ints. Wipe off the grease from the hydraulic Add oil and grease at all lubrication po When the machine is stored for a long p eriod, moisture in the air will mix with the oil. Check the o il befor e and after starting the engine. If there is water in the oil, change all the oil. STARTING MACHINE AFTER LO NG-TERM STORAGE When starting the engine after the machin e has been in storage for a long period, carry out the warming-up operation thoroughly. For details, see the procedu re in "WARMING UP OPERATIONS (PAGE 3-98) ".