. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION it. Tightening torque: 2.0 to 3.9 Nm (0.2 to 0.4 kgm , 1.4 to 2.9 lbft) that no more until no more Tightening torque: 4.9 to 6.9 Nm (0.5 to 0.7 kgm , 3.6 to 5.1 lbft) 8. Continue pumping (approx. 50 times) until the priming pump (2) becomes stiff and the overflow valve release 3 - 144 AFTER RUNNING OUT OF FUEL When st arting the engine a gain after running out of fuel, fill with fue l, then bleed the air from the fuel system before starting t he engine. and be careful not to run out of fuel.
Always w atch the fuel level and be careful not to run out of fuel I f the eng ine has stopped b ecause of lack of fuel, it is necessary to u se the priming pump to b leed the air completely from the fuel circuit. This en gine consists of high er precision parts than on the conventional fuel inj ection pump and nozz le, so if dirt gets in, it will cause problems. If there is any dirt stuck to the fuel line, use fuel to wa sh it off completely. Be care ful when opening th e air bleed plug at the f uel filter head and th e air bl eeder of the supply pump. The system is still under pressure and fuel ma 1. Loos en air bleed plug ( A), (B) at the fuel filte 2. Loos no m 3.
Wrap en the knob of prim ore bubbles come sealing tape arou ing pump (2), then pu out of air bleed plug nd air bleed plug (A) 4. Oper ate the priming p ump again and che bubb les come out with the fuel from air blee 5. Tight en air bleed plug ( Tight ening torque: 4.9 t o 6.9 Nm (0.5 to 0.7 kg 6. Loos en air bleeder (3) of the supply pump. 7. Pum p priming pump (2 ) approx. 90 - 100 tim les come out with t eeder (3). 8. Cont inue pumping (app d becomes contin