. OPERATION TROUBLESHOOTING PRECAUTIONS WHEN CONNECTING AND DISCONNECTING BOOSTER CABLE WARNING in the booster cable connections. 3 - 147 When connecting the cables, nev (-) terminals. When starting the engine with a b rubber gloves. Be careful not to let the normal m each other. This prevents sparks f could ignite the hydrogen gas gi Make sure that there is no mista The final connection is to the eng sparks will be generated when thi as possible from the battery. When disconnecting the booster in contact with each other or with NOTICE clip should be suitable for the battery size. e must be the same capacity as that of the engine to be started. mage or corrosion. ps are firmly connected.
The size of the booster cable and The battery of the normal machin e must be the same capacity as that of the en gine to be started. Check the cables and clips for da Make sure that the cables and cli Check that the work equipment l ock levers and parking brake levers of both m achines are in the LOCK position Check that each lever is in the N EUTRAL position. CONNECTING THE BOOSTER C ABLES ormal machine and problem machine in the OFF position. llows, in the order of the numbers marked in the diagram. able (A) to the positive (+) terminal m machine. r end of booster cable (A) to the ry (D) on the normal machine. able (B) to the negative (-) terminal machine.
end of booster cable (B) to engine chine. Keep the starting switch of the n ormal machine and problem machine in the OFF position Connect the booster cable as fo llows, in the order of the numbers marke d in the diagram. 1. Connect the clip of booster c of battery (C) on the proble 2. Connect the clip at the othe positive (+) terminal of batte 3. Connect the clip of booster c of battery (D) on the normal 4. Connect the clip at the other block (E) on the problem ma 1. Connect the clip of booster c STARTING THE ENGINE ly connected to the battery terminals. ter machine and keep it running at high idling speed. 1. Make sure the clips are firm 2. Start the engine of the boos 3.
Turn the starting switch of p start at first, try it again after 1. Make sure the clips are firm ly connected to the battery terminals. 2. Start the engine of the boos ter machine and keep it running at high i dling 3. Turn the starting switch of p roblem machine to the START position, a nd start the engi ne. If the engine d oesn' 2 minutes.