. MAINTENANCE SERVICE PROCEDURE CLEANING OUTER ELEMENT NOTICE Before and after cleaning the element, do not leave or keep it in direct sunlight. holders (2), then remove cover (3) and take out outer element (4). 4 - 25 1. Re move 6 h NOTICE Neve r remove t he inner element (5). It will allow dirt to e nter and cause failur e of the en gine. rewdriver or other tool. Do no t use a sc rewdriver or othe 2. Hol d the out er element (4), move it carefully up a nd down and to t whi he left an d right, and rota te the element to the left and right le pulling it out. ing the outer e lement, cover the air connector 3.
Afte r remov insi dirt de the air cleaner body w ith a clean cloth or ta pe to prevent or dust f rom entering. 4. Use a brush or cloth to remo ve all the dirt stuck to cover (3) and the inside of air cleaner bod y (6). (Max. 0.69 MPa (7 kg/cm2, 99.4 5. Dir ect dry c ompressed air PSI dire aga 1) 2) )) from th e inside of the o uter element along it s folds. Then ct the co mpressed air fro m the outside along t he folds, and in from t he inside. hat the inner el securely. ement is not loose. If it is loose, Check t insert it If the yel low piston over laps the red zone (A) on the outer diamete r immediately a fter the outer elemen t is cleaned, replace both the inner a nd outer elements.