. MAINTENANCE SERVICE PROCEDURE 4 - 26 NOTICE If small holes or thinner parts are f ound on the element when it is checked with an electric bulb after cleaning and drying, r eplace the element. t hit it or beat it against something. s or gasket or seal are damaged. When cleaning the element, do no Do not use an element whose fold 6. If small holes or thinner pa rts are found on the element when it is checked with an elec replace the element. tric bulb after cleaning and drying, NOTICE The inner element must not be cleaned and used again. When replacing the outer element, replace the i nner element at the same time.
If the inner element is not insta lled properly and the outer element and cover are installed, there is damaged. danger that the outer element will be The seal portion on imitation pa rts lacks precision, and allows the entry of dust, which leads to damage parts. of the engine. Do not use such imitation 7. Remove the cloth or tape cover installed in Step 3. 8. Check that there is no dirt or oil stuck to the seal portion of the new element or cleaned el ement. Wipe off any dirt or oil. 9. Push the outer element in straight with your hand when er body. installing it to the air clean If the outer element is held to the left and right while pu inserted easily.
and rocked lightly up and down and shing it in, the outer element can be NOTICE When inserting the element, if the rubber at the tip is swollen or the outer element is not pushed in straight, and cover (3) is assembled by force to hook (2), there is danger that th e hook and air cleaner body may be embling. damaged, so be careful when ass 10. Install cover (3) as follows . element. 2) to the protruding part of the air it in position.
1) Align cover (3) with the 2) Hook the tip of hook ( cleaner body and lock 3) When locking hooks (2 on opposite sides (top, as when tightening bol 4) When cover (3) is in between the air cleane If it is too large, install ) in position, apply the hooks in turn bottom, left, right) in the same way ts. stalled, check that the clearance r body and cover (3) is not too large. again.