Komatsu — REVERSE AND REPLACE THE END BITS AND CUTTING EDGES

. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES WARNING equipment lock lever. Tightening torque: 1499 ± 157 Nm (153 ± 16 kgm , 1106.6 ± 115.7 lbft) 6. After several hours of running, retourque the nuts. REMARK The tightening operation is easier if the power wrench that has been supplied is used. 4 - 34 It is dangerous if the work eq uipment moves by mistake when the cutting edges and end bits are being reversed or replac with work Reverse or replace the en d bits and cutting edges before i t is wor n out to the blade end roper height, position a block un der the frame to prevent the blade from falling. ipment lock lever to the LOCK p osition.

the end bit on both sides are w orn out, replace with new one e is worn, correct it before turnin move bolt (2). Then remove the cutting and clean the mounting surface. cutting edge and the end bit whe n worn e damaged, replace them with ne w ones e blade, then tighten partially. Drop the s on to the ground or rock to remo ve any ghten it to the correct tightening torque. t (3), put top surface (4) of the en d bit in pper (5), then tighten with the bo When the nut is rusted an d is removed by gas cutting, cut on both side (6) of the nut as sho wn in the diagram. seat surface (7). t. Be careful not to get spatter on the Be careful not to damage If it is damaged, repair i mounting surface.