Komatsu — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE EVERY 500 HOURS SERVICE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING front of the directly (2) slowly to much that the Nm (7 ± 1 7.2 lbft) ± 1. ± 10.8 lbft) particles or 4 - 55 Maintenance for e very 250 hours should be perform (including engine b y-pass filter cartridge) The oil is at high tem perature after the engine has been op erated, so never change the oil immediately a fter finishing operations. Wait for the oil to coo l down before changing it. Refill capacity: 5 Prepare a socke 1. Remove the c machine and underneath to overs at the bottom left at th on the side face, and put a con catch the drained oil.

plug (1) and loosen drain valve 2. Remove drain avoid getting oil on yourself, and drain the oil. Take care not to loosen drain valve (2) so stopper pin in the valve is distorted. Tightening torque for drain plug (1) : 68.6 ± 9.8 kgm, 50.6 Tightening torque for drain valve (2): 63.7 ± 14. 5 kgm, 47. 3. Check the drained oil, if there is excessive met il on yourself, and drain the oil. to loosen drain valve (2) so he valve is distorted. ue for drain plug (1) : 68.6 ± 9.8 foreign materia l, contact your Komatsu distribut 4. Tighten drain v alve (2), then tighten plug (1). 5. Using the filter wrench, turn engine oil filter cartr left and remov e it. 6.

Clean the filter holder, fill the new filter cartridge coat the packin thinly with grea g surface and thread with engin se), then install the filter cartridg 7. When installin into contact wit g the filter cartridge, bring the pa h the filter holder, then tighten a f turn. 8. After replacing the filter cartridge, add engine filler port (F) un the dipstick. til the oil level is between the H a 9. Run the engine at idling for a shot time, then sto p the engine, and check that the oil leve l is between the H and L marks on the dipstick. For details, see "CHEC K OIL LEVEL IN ENGINE OIL PAN, AD D OIL (PAGE 3-77)".