. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING the final drive REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING Replace the element when the oil is cold. When removing breather cap (1), turn it slowly to release the internal pressure before removing it. 4 - 59 There is danger that oil may spurt out under i nternal p ressure, s o stan d to the side, and gradually turn the plug to release int erna pressure before remov 1. Place the machi ne on a horizontal p 2. Remove oil leve l plug (G) and che ck whether case is filled wit h oil to lower edge o f the plug h 3.
If the oil level is still too low, add oil throug h oil filter plug hole (F) until the oil o verflows. Before removing oil plug (F), remov e all the mu d an d dirt f rom around oil filler p lug (F). Be careful no t to let any dirt o r sand get in when adding oil. 1. Remove breath er cap (1) on the top of the hydraulic tank. 2. Replace elemen t (2) inside the cap.