Komatsu — REPLACE ADDITIONAL FUEL FILTER CARTRIDGE (IF EQUIPPED WITH MACHINES)

. MAINTENANCE SERVICE PROCEDURE REPLACE ADDITIONAL FUEL FILTER CARTRIDGE (IF EQUIPPED WITH MACHINES) WARNING Container to catch the oil Prepare a filter wrench 1. Close the fuel valve. 2. Set the container to catch the fuel under the additional fuel filter cartridge. 3. Using a filter wrench, turn filter cartridge counterclockwise to remove it. 4. After removing the filter, remove transparent bowl (1) and inspect it. If there is any damage, replace it with a new part. 5. Clean transparent bowl (1) and remove seal (2). Coat new seal (2) with clean fuel or oil, then install it. 6. Install transparent bowl (1) to new filter cartridge (3). Tightening torque: 10 Nm (1 kgm , 7.2 lbft) 7.

Check that drain plug (4) at the bottom of the transparent bowl is tightened securely. Tightening torque: 0.2 to 0.45 Nm (0.02 to 0.046 kgm , 0.1 to 0.3 lbft) 8. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. 4 - 60 After the engine has been operate d, all parts are at high temperature, so do not repla ce the filter imme diately. Wai t for a ll parts to cool down before starting the operation. the engine fuel piping system when the engine is running.

High pressure is generated inside the engine fuel piping system when the engine i When replacing the filter, wait fo r at least 30 seconds after stopping the engine to let the internal p ressure go down before replacing the filter. se. leed plug in the fuel filter head. It is still under pressure, so fuel may spurt out. Do not bring any fire or flame clo Be careful when opening the air b leed plug in the fuel filter head. It is still under p ressure, so fuel m ay spurt out NOTICE Genuine Komatsu fuel filter cartr idges use a special filter that has highly efficient filtering ability. When replacing t he filter cartridge, always use a genuine K omatsu part.

The common rail fuel injection sy stem used on this machine consists of more pre cise parts than th e conventional in jection pump and nozzle. If any part other than a genuine K omatsu filter cartridge is used, dust or dirt may ge t in and cause pr oblems with the in jection system. Always avoid using sub stitute parts. When carrying out inspection or maintenance of the fuel system, pay more attentio n than normal to the entry of dirt. If dirt is stuck to any part, use fuel to was h it off completely.