Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING temperature immediately after the engine is stopped, and may cause burns. Wait for the and L marks. C (50 to 86 ° F)) C (122 to 176 ° F)) 3 - 80 The parts and oil are at high temperature to go down before When removing the oil filler cap . Set the work equipment in t he posture shown in the diagram on the right, then check the oi l level and add oil if necessary. not in the condition shown in the the engine, run the engine at low . If the work equipment is diagram on the right, start speed, retract the arm an lower the boom, set the buc and stop the engine. .

Within 15 seconds after d bucket cylinder rods fully, then ket teeth in contact with the ground, stopping the engine, move each control lever (for work equ in all directions to release ipment and travel) to the full stroke the internal pressure. . Check sight gauge (G). Th e oil level should be between the H . If the level is below the L m ark, add oil through oil filler (F) at the top of the hydraulic tank. REMARK The oil level will vary dependin Accordingly, use the following Before starting operation: B (Oil temperature 10 to 30°C Normal operation: Around (Oil temperature 50 to 80°C NOTICE Do not add oil above the H line.

T his will damage the hydraulic circuit or cause the oil to spurt out. the H level, swing the upper structure If oil has been refilled, exceeding until drain plug (P) beneath the hyd raulic tank comes between the right and lef t track shoes and stop the e ngine. Wait for the oil to cool down sufficiently, then remove cover (1) and drain the excess oil through drain