. MAINTENANCE MAINTENANCE PROCEDURE NOTICE Do not operate the swing under any circumstances. left and right. This will 4 - 44 BLEEDING AIR FROM HYDR AULIC SYSTEM For details, see "STARTING EN GINE (PAGE 3-93)". If it is necessary to refer to the items for starting the engine, moving the machine off, steering , or stopping, see the OPERATION section. d check that oil oozes out from the t, remove the drain hose from the d fill the pump case completely drain port (2). firmly, keeping the mouthpiece the hydraulic tank so that oil will eed operation, tighten air bleeder ose. 1. Bleeding air from pump 1) Loosen air bleeder (1) an air bleeder.
2) If the oil does not ooze ou hydraulic pump case an with hydraulic oil through Hold the removed hose higher than the oil level in not spill out of the hose. 3) After completing the air bl (1) and install the drain h 1. Bleeding air from pump d check that oil oozes out from the t, remove the drain hose from the d fill the pump case completely drain port (2). firmly, keeping the mouthpiece the hydraulic tank so that oil will 3) After completing the air bl eed operation, tighten air bleeder NOTICE will spurt out from bleeder hole (1).
If the drain hose is installed first, oil If the pump is operated without fillin g the pump case with hydraulic oil, abnormal heat will be genera ted and this may cause an unexpected damage to the pump. 2. Starting engine Start the engine, referring to Run the engine at low idle fo 3. Bleeding air from cylinders 1) Run the engine at low idl not moved to the end of i 2) Next, operate each cylin 3) Finally, operate each cyli 1) Run the engine at low idl e, and extend and retract each cylinder 4 to 5 times, takin g care that a cylinder is ts stroke. (Stop the cylinder approx. 100 mm (3.9 in) shor t of its stroke end) move the air.
2) Next, operate each cylin der 3 to 4 times to the end of its stroke. 3) Finally, operate each cyli nder 4 to 5 times to the end of its stroke to completely re NOTICE If the engine is run at high speed imm ediately after startup or a cylinder is pushed up to its stroke end, a ir taken inside the cylinder may cause damage to the piston pac king. 4. Bleeding air from swing moto r 1) Run the engine at low idli check that oil oozes out f ng, loosen hose (3) at port S, and rom port S hose (3). 2) If oil does not ooze out, stop the engine, remove port S hose (3), and fill the insid oil.
e of the motor case with hydraulic 3) After completely bleeding 4) Run the engine at low id le and slowly swing at least two times uniformly to the ir from the swing circuit. automatically bleed the a