Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE (4), and from 4 - 45 NOTICE If the air is no t bled from the s wing motor, th e motor bear ings ma When replaci ng the travel mot or safety valve, please cont act your Komatsu distributor to hav e it replaced and to have t he air bled. 5. Bleeding a ir from travel m (Bleed the air only when t he oil inside t he travel m 1) Run th e engine at lo tighten it when oil flow 2) Run th e engine at low idle and swing the wor 90° to bring it to the si de of the track. 3) Jack u p the machine until the trac k is the gro und. Rotate th e track under no load for Repea t this procedure on both the left and rig ht sides 6.

Bleeding a ir from attachm ent (when installed) I f a breake r or other attach ment has been i nstalled , run th e engine at low idle and o perate the attachment peda repeatedly (approx. 10 tim es) until the air has bee n bled f rom the attachment circ uit. NOTICE If the method of bleeding the air from the attachment its elf is specified by the manufacture r, bleed the air ac cording to the specified pro cedure. After complet ing the air bleedi ng operation, s top the engi ne, and leave the machine for 5 min utes before starti ng operations. This will rem ove the air bubble s in the oil inside the hydr aulic cylinders. that has been spilled.

Chec k that th ere is no leakage of oil and wip e of f any oil that has After complet ing the air bleedi ng operation, i nspect the o il level, a nd if the oil level is low, ad