. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING position (S). the left to 4 - 56 After the engine has bee n operated, all parts are at high tem perature, so do not replace the filter imm ediately. Wait for all parts to cool down before star ting the operation. ed inside the engine fuel piping system when the engine is running. High pressure is generat ed inside the engine fuel piping s When replacing the filte r, wait for at least 30 seconds afte r stopping the engine to let the internal pressure go down before replacing the filter. lame close.
Do not bring any fire or f NOTICE Genuine Komatsu fuel fi lter cartridges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a g enuine Komatsu part. The common rail fuel inj ection system used on this mach ine consists of more precise parts than t he conventional injection pump and nozzle. If any part other than a g enuine Komatsu filter cartridge is used, dust or dirt may get in and cause pr oblems with the injection system. Always avoid u sing substitute parts. When carrying out inspe ction or maintenance of the fuel s ystem, pay more attention than normal to the entry of dirt.
If dirt is stuck to any part, use fu el to wash it off completely. Container to catch the Prepare a filter wrenc 1. Turn the valve (1) at the bottom of the fuel tank to t 2. Open the cover on t he right side of the machine. 3. Set the container to c atch the fuel under the pre-filte 4. Loosen drain valve ( 2), then drain all the water and the transparent cap cartridge (4). (3) and also the fuel accumula 5. Remove connector ( 5). Wrap the removed connect bag to prevent water 6. Using a filter wrenc remove it. (This cap 7. Using a filter wrench , turn cartridge (4) to the left to 8. Install transparent ca p (3) to the bottom of the new (When doing this, al ways replace O-ring (6).)