Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE securely to the fixed tightening angle. 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. not to let water get on the (5), dry it completely before 4 - 57 9. When installing, apply oil to th e packing surface and bring the packing surface into cont act with th e seal sur tighten it further by 1/4 - 1/2 turns. ened too much, the O-ring will be damaged a nd this will ca use leakage of fuel will leak through the gap at the O-ring . To prevent these p roblems, always tig NOTICE When adding fuel, do not remove small holes (A) on the dirty side.

After adding fuel, remove cap (B) Always fill with clean fuel. Be care the fuel. In particular, center portio cap (B) when adding fuel. Be caref portion on the clean side. 11. When installing, tighten until t he packing surface contacts the seal surface of the filter h older, the n tighten i of a turn. If the filter cartridge is tighten filter cartridge is too loose, fu When tightening with a filt ed too far, the packing will be damaged and this will lead to leakag e of fuel. I el will also leak from the packing, so always tighten the c er wrench, be extremely careful not t o dent o r damage the 12. Check that the drain valve (2 13.

Remove the vinyl bag coveri ng connector (5), then connect connecto r (5) REMARK If water gets on the connector and the water separator moni connector (5), be extremely c connector. If water gets on connector connecting it. 14. Turn the valve (1) at the bott om of the fuel tank to the OPEN position (O) 15. After completing the replace ment of filter cartridge (4), bleed the a ir. Bleed the air as follows: 16. Add fuel to the fuel tank until full (to FULL mark on the fuel gauge