. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN DAMPER CASE, ADD OIL WARNING is stopped and may cause serious burns. Wait for the oil 2. Remove plug (P) and check that the oil is up to near the bottom of the plug hole. If the oil level is low, remove cap (F) and add oil through the oil filler port to the bottom of the hole of plug (P). NOTICE If excess oil is supplied, drain it to the specified amount to avoid overheating. 3. Install plug (P) and cap (F). 4. Close the door. Komatsu distributors for REMARK 4 - 71 Parts and oil are at high temperature immediately afte r the engin temperature to go d own before performing thi s operati on.
NOTICE Park the machine on flat ground and stop the e ngine. A fter waiting f or more than 30 minutes after st opping the engine, check the oil level. r on the left side of the machine . CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS Please ask your K omatsu distributor to c heck the tightening of the clamps between the air cleaner - turbocharger - aftercooler - eng ine. CHECK FAN BELT AND ALTERNATOR DRIVE BELT TENSION, REPLACE Special tools are required for inspection and replacement of the fan belt. Contact your placement. inspection and re An installed auto f an belt tension adjuster , "Auto T ensional F an Belt", dispenses with the b elt deflection adjustment.
CHECK NITROGEN GAS CHARGE PRESSURE IN ACCUMULATOR (for break (If equipped) eeded for inspecting and charging with nitrogen gas. su distributor inspect and charge the accumulator. A special tool is n eeded for inspecting an d charg ing with nit rogen Have your Komat su distributor inspect an d charg e the accumulator.