Detroit Diesel — Engine Data List

Appendix A • Parameter Listings 146 Detroit Diesel Application User’s Manual Parameter Description OPTIMIZED IDLE Indicates the enabled/disabled status of the opti- mized idle feature that is programmed in the DDEC calibration. OVERRIDE Indicates the active/inactive status of the idle shutdown override feature. PULSEWIDTH Number of degrees crankshaft rotation that the EUI’s control valve is closed and fuel is entering the cylinder. PWM DRIVE 1 Indicates the duty cycle of the Pulse Width Modulated (PWM) port #1. PWM DRIVE 2 Indicates the duty cycle of the Pulse Width Modulated (PWM) port #2. PWM DRIVE 3 Indicates the duty cycle of the Pulse Width Modulated (PWM) port #3.

PWM DRIVE 4 Indicates the duty cycle of the Pulse Width Modulated (PWM) port #6. R1 INLET TMP Indicates the receiver ECM #1 (MID 175) temperature of the air entering the engine air induction system in degrees Fahrenheit or Celsius. R1 BOOST Receiver ECM #1 (MID 175) Boost Pressure - Pressure of air measured downstream on the com- pressor discharge side of the turbocharger. R1 SRS RECEIVED Indicates that the receiver ECM #1 (MID 175) has received a signal from the Synchronous Reference Sensor (SRS) during this ignition cycle. R1 ECM VOLTS Indicates the receiver ECM #1 (MID 175) battery voltage available to the ECM. R1 PULSEWIDTH Receiver ECM #1 (MID 175) Fuel Pulse Width.

• R1 TPS CNTS (STANDARD) • R1 ALT THROT CNTS (MARINE) Indicates the receiver ECM #1 (MID 175) Throttle Position Sensor (TPS) Counts (CTS) - A/D Counts. For marine engines, indicates the alternate throttle counts. “N/A” will be displayed if the A/D port mask for Throttle Position is disabled as indicated by DDEC Unique ID 223.