DDEC Engine Parameters Detroit Diesel Application User’s Manual 145 Parameter Description GAS VALVE Indicates the percent opening of the natural gas metering valve. HALF ENGINE Indicates the active/inactive status of the Half Engine Mode. INACTIVE CODES Indicates (Yes or No) if an inactive Fault Code has been present. IDLE SPD RPM Indicates the current engine idle speed in RPM. INJECT PRS PSI Indicates the injection fuel rail pressure in PSI or KPa. INJ PUMP USAGE Indicates the injection fuel rail pump utilization. ISD OPTION Indicates the state of the idle shutdown feature. INTKE AIR TMP Indicates the temperature of the engine intake air degrees Fahrenheit or Celsius.
INTRCOOL TMP Indicates the temperature of the engine intercooler degrees Fahrenheit or Celsius. KNOCK CONTROL Indicates the active/inactive status of the Knock Control Mode. KNOCK LEVEL A description of the relative knock intensity. The higher the numbers the higher the knock. KNOCK VOLTS Indicates the knock sensor voltage available to the ECM. LOOP STATUS Indicates the open/closed loop status of the fuel system based on the signal from an exhaust oxygen sensor. OIL FILTR RS Indicates the relative amount of restriction measured at the Oil Filter, in PSI or KPa. OIL LEVEL Indicates the engine oil level. Will display OK or ADD.
While the engine is running, and for a while after shutting off the engine, OIL LEVEL will display UNKNOWN. OIL PRS PSI Indicates the engine oil pressure in PSI or KPa. OIL TMP Indicates the temperature of the engine oil in degrees Fahrenheit or Celsius.