Appendix A • Parameter Listings 144 Detroit Diesel Application User’s Manual Parameter Description ENG GOVR Indicates which DDEC governor is currently active. ENG GOVR GAIN Overall governor gain. ENG LOAD PCT Indicates the percent engine load calculated from engine speed and torque. ENGINE RPM Indicates engine RPM as determined by the timing reference sensor. EXST BKPRS Indicates exhaust back pressure in Hg or KPa. “FAIL” will display if FMI 3 or FMI 4 is received. EXST BP FAULT TIMES Exhaust back pressure fault times. • SCLD HI • Exhaust back pressure time while scaled high fault active, indicated in hours/minutes.
• RAMP DN • Exhaust back pressure time while ramp down fault active, indicated in hours/minutes. EXHST GAS AFR Indicates the engine exhaust gas air fuel ratio. EXST TMP A Indicates the temperature of the engine exhaust gas in degrees Fahrenheit or Celsius. For marine engines, indicates exhaust bank A temperature. “FAIL” will be displayed if a FMI 3 or FMI 4 is received. EXST TMP B Indicates the temperature of the Receiver ECM #2 (MID 175) engine exhaust gas in degrees Fahrenheit or Celsius. For marine engines, indicates exhaust bank B temperature. “FAIL” will be displayed if a FMI 3 or FMI 4 is received. EXT PUMP PSI Indicates water pressure of an external water pump drive in PSI or KPa.
FUEL IN RES Indicates the restriction measured at the Fuel Pump Inlet, inches of Hg or KPa. FUEL PRS PSI Indicates the engine fuel pressure in PSI or KPa. FUEL TMP Indicates the temperature of the engine fuel in degrees Fahrenheit or Celsius. FUEL RATE GPH OR LPH Indicates the amount of fuel consumed by the engine per unit time.