Appendix A • Parameter Listings 1 These features are only available on ECM with Software Level 2.0 or higher. VSG (Marine Throttle) Calibration The following table lists the parameters that allow the reprogramming of the DDEC III/IV engine variable speed governor options. 156 Detroit Diesel Application User’s Manual Parameter Description • VSG DROOP RPM (STANDARD) • THROT DRP RPM (MARINE) Indicates the variable speed governor droop in RPM that is programmed in the DDEC calibration. For marine engines, this is the amount of Throttle Droop. • VSG MIN RPM (STANDARD) • LOW IDLE RPM (MARINE) Indicates the minimum variable speed governor RPM that is programmed in the DDEC calibration.
For marine engines, this is the low idle set point RPM. • VSG MAX RPM (STANDARD) • THRT MAX RPM (MARINE) Indicates the maximum variable speed governor RPM that is programmed in the DDEC calibration. For marine engines, this is the maximum Throttle RPM. • ALT VSG MIN RPM (STANDARD) • USER IDLE RPM (MARINE) Indicates the alternate variable speed governor minimum RPM that is programmed in the DDEC calibration. For marine engines, this is the normal user idle set point. “N/A” will be displayed if (Func- tion #16 - ALT VSG MIN) is not configured as a vehicle input switch.