Detroit Diesel — Cruise Control Calibration

Appendix A • Parameter Listings Cruise Control Calibration The following table lists the operating conditions necessary for the cruise control parameters to be available. 174 Detroit Diesel Application User’s Manual Parameter Range Description VSS ENABLED YES, NO or N/A Allows the vehicle speed sensor to function. A VSS must be present on the vehicle for this to function. If the engine has sequential Turbo, reprogramming will not be allowed. VSS TYPE 1,2 TAIL, WHEEL J1939, or N/A Allows the selection of the vehicle speed sensor type. VSS TEETH2 0 to 250 or N/A Allows the selection of the number of teeth that the VSS is to detect.

VSS SIGNAL2 (STANDARD) THRT SIGNAL (MARINE) Switched, Magnetic, or N/A Indicates the type of VSS signal for. For marine engines indicates the type of throttle signal. “N/A” will be displayed if VSS ENABLED = NO. TIRE REVS2 100 to 999 or N/A Allows selection of tire revolutions per mile or kilometer. AXLE RATIO2 2.00 to 19.99 Select the vehicle axle ratio. TOP GEAR2 0.20 to 2.55 Select the top gear ratio. VEHICLE SPD LMT2 YES, NO or N/A This puts an upper limit on the speed of the vehicle. VEHICLE SPD3 ⎛ ⎝ 10 MPH to RATED RPM VSS RATIO Allows programming of the maximum vehicle speed in MPH or KPH.

VSS ANTI-TAMPER3 YES, NO or N/A Allows selection of a feature that can detect if the VSS has been tampered with. CRUISE CONTROL YES, NO or N/A Allows the cruise control function to be used. A Set/Coast on switch must be configured.