DDEC Marine Controls Parameters Detroit Diesel Application User’s Manual 199 Parameter Range Description PORT TROLL ENG YES/NO Indicates that the Port trolling actuator is engaged. PORT SHAFT RPM 0-3000 Indicates the actual Port shaft RPM. Only on trolling applications. PT SHAFT CMD RPM 0-3000 Indicates the requested Port shaft RPM from the CSIM. Only available for version 2.0 and 2.5 marine controls. STBD PRESS SW ON or OFF Indicates whether the Starboard gear pressure switch is closed. Only avail- able for version 2.0 and 2.5 marine controls. Note: This will indicate “OFF” if no pressure switch is installed. STBD SHAFT RPM 0-3000 Indicates the actual Starboard shaft RPM.
Only on trolling applications. STBD TROLL ENG YES/NO Indicates that the Starboard trolling actuator is engaged. TRANSFER CSIM YES or NO Indicates that a transfer of control station is in progress. TROLL ENG RPM 0-9999 Indicates the current engine RPM being commanded while in troll mode. SET TRL ENG SPD YES or NO Indicates that the ERIM is in the mode of setting a new troll engine speed. ST SHAFT CMD RPM 0-3000 Indicates the requested Port shaft RPM from the CSIM. Only available for version 2.0 and 2.5 marine controls. PORT TROLL POS% 0.0 to 100 The actual position of the Port troll actuator. Only available for version 3.0 marine controls.
PORT TROLL CMD% 0 to 100 Indicates percent troll commanded by the CSIM on the Port side. Only available for version 3.0 marine controls.