. MAINTENANCE MAINTENANCE PROCEDURE Mixing rate of water and antifreeze -40 -40 20.1 15.9 5.31 4.20 58 WARNING resistor resistor). 4 - 26 To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant d 68%. between 30% an When deciding th e ratio of antifreez e to water, check t he lowest temperature in t he past, and decide from the mixing table given below . er to estimate and temperature about 10°C (18°F) lower when deciding the mixing ratio. depends on the ambient temperature, but it should always be a minimum of 30% by volume amount of coolant x 100).
It is actually bett er to estimate and temperature abou t 10°C (18°F) lowe r when deciding the mixin The mixing ratio depends on the always (antifreeze/total amount of coolant Even in areas wh ere it is not neces sary to prevent fre ezing, use Supercoolant ( AF-NAC) at a mixin g ratio of at least 30% to prevent c orrosion of the co oling system. The freezing tem perature of undilut ed antifreeze is -1 5°C (5°F). Do not store u ndiluted antifreeze at a temperature of below -15°C ( 5°F). Min.
atmosph temperatur eric °C A e °F A bove-10 -15 -20 -25 -30 -35 bove14 5 -4 -13 -22 -31 Amount of antifr liter eeze US gal 10.8 13.0 14.8 16.6 18.0 19.4 2.85 3.43 3.91 4.39 4.76 5.13 liter 25.2 23.0 21.2 19.4 18.0 16.6 ter US gal 6.66 6.08 5.60 5.12 4.76 4.39 Volume ratio (%) 30 36 41 46 50 54 Antifreeze is fla mmable, so keep it a way from flame. Antifreeze is tox ic. When open the d rain valve, be carefu l not to get wate r containing antifreeze on you. If it gets in your eyes, flush your eyes with large amount o f fresh water and se e a doctor at once.
When changing the coolant or draini ng the coolant from the radiator before c arrying out repairs, ask a spe cialist company to handle any coo lant containing antif reeze, or contact y our Komatsu distributor. Antifreeze is toxic, so never pour it into e. istributor. A drainage water ditches or drain it on to the ground surfac Use antifreeze an d appropriatewat er for diluting. (for d etails, see "COOLANT A ND WATER FOR D ILUTION (PAGE 4-5)") use of an antifreeze density gauge to control the mixing proportions.
We recommend use of an antifreez e density gauge t o control the mixin Prepare a contai ner whose capacit y is larger than th e specified coolant volum e to catch drained Prepare a hose t o supply antifreez e coolant and wat . Stop the ma chine on level gro und, then stop the . Open the fr ont engine hood and tighten corro places). (Only ma chines equipped w