Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE 4 - 28 12. I nstall the cove rs (4) and (5) 13. Replace the co rrosion resistor, an d ope n val ve (1).(Onl y machines equipped with co For details of replacement of cartridg ORROSION CARTRIDGE ( PAGE 4-74)" 14. Add coolant m ixed with antifreeze until i t overflows fro m the water f Decide the pro portions of antifreez e and wate r accordin g to the table for the mixing rat e of water and antifreeze. 15. Run the engine at low idling f or 5 m inute s to r emove the air from the water, then run at high idling for 5 minutes. Leave radiato r cap (3) removed when doing this. ) 16.

Open the rear engine hood, drain t he w ater fr om sub-ta wash the insid e of the sub-tank, then between the F ULL and LOW mark If the sub-ta nk is extremely dirt replace it wi th a new part. 17. Stop the engin e, wait for approx. 3 minutes, add city w o near the mo uth of the filler port, t hen ti ghten radiator c 18. I nstall cover (2 19. Close the engi