Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING stopped, and may cause burns. Wait for the 4 - 70 The parts and oil are at high t temperature to go down before When removing the oil filler cap , turn it slowly to release the internal pressur OTICE f the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket hydraulic breaker, the hydraulic oil wil perations. For details, see "M maintenance. AINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out 1.

Set the work equipment o n the hard and flat ground in the maintenanceposture as sh ground and stop the engine own in the figure, then lower it to the . 2. Remove the cap from oil pressure. filler (F), and release the internal e cover (1). 3. Loosen 4 bolts, then remov When doing this, the cover (2), hold the cover down w may fly out under the force of spring hen removing the bolts. valve (3) and strainer (4), take out filter case for dirt, and remove it, if 4. After removing spring (2), element (5). Inspect the bottom of the any. Take good care th hydraulic tank.

en not to let fall the dirt into the EMARK f the mounting bolts of cover (1) loosened in Step 3 are left for l pressure inside the case will be pprox. 5 minutes, the interna eleased, so if the element is re moved when the oil in the element as drained out, the amount of dripping oil will be reduced. 5. Clean the removed parts in flushing oil. 6. Install the new element in th e place where old element (5) was installed. 7. Set valve (3), strainer (4) a nd spring (2) on top of the element. 8. Set cover (1) in position, pu sh it down by hand, and install the cove r with the mounting bolt 9. Screw in the oil filler cap an 10.

To bleed the air, start the e ngine according to "STARTING ENGINE idle for 10 minutes. 11. Stop the engine.