Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Adjustment WARNING backrest. (B) Adjusting reclining that is 3 - 63 Adj ust the seat position befor e starting operations or after c hanging th Adj ust the seat so that the co ntrol levers and switchis can b e operated freel y and easily with the op erator back against the Seat Adjustment (A) Fore-and-aft adjustment (A) Fo Move lever (1) to the upper, s et the operator's seat at the positi on, then release the lev Fore-and-aft adjustment:

50 REMA The s eat can be reclined more when the seat is pushed to The a mount of reclining decre ases as the seat is pushed back, when positi Pull up lever (2) and set t he backrest to a position comfortable for operation, the Sit wit h your back against the seat backrest when adjustin back i s not against the backre st, the backrest may sudde forwa (C) A djusting armrest angle pring up by hand approx. 90°. Armre st (3) can be made to s pring up by hand approx. 9 In add ition, by turning the dial (4) at bottom of armrest by hand i t is possible to make fine verti cal adjustment of the armre st angle. °. Armre st adjustment angle:

25 REMA RK If the seat back is tipped to th e front without raising the a rmrest (3 ), the armrest will rise auto (D) O verall fore-and-aft adjus tment of seat Move lever (5) to right. After t he seat is set to the desired position, relea se the lever (5). In this case, the operator's seat, left and right control lev ers, and lock lever all slide t Fore-and-aft adjustment: 100